Accessories Series
The drive shaft, tensioning cylinder, one-way valve, end cover kit and threaded shaft kit produced by our company are suitable for micro-digging. After the accessories are quenched and tempered, the surface is subjected to intermediate frequency quenching treatment to ensure reasonable hardness and wear resistance of the outer surface.
The drive shaft, tensioning cylinder, one-way valve, end cover kit and threaded shaft kit produced by our company are suitable for micro-digging. After the accessories are quenched and tempered, the surface is subjected to intermediate frequency quenching treatment to ensure reasonable hardness and wear resistance of the outer surface.
JGCL-05 hole flange connection
The drive shaft, tensioning cylinder, one-way valve, end cover kit and threaded shaft kit produced by our company are suitable for micro-digging. After the accessories are quenched and tempered, the surface is subjected to intermediate frequency quenching treatment to ensure reasonable hardness and wear resistance of the outer surface.
The drive shaft, tensioning cylinder, one-way valve, end cover kit and threaded shaft kit produced by our company are suitable for micro-digging. After the accessories are quenched and tempered, the surface is subjected to intermediate frequency quenching treatment to ensure reasonable hardness and wear resistance of the outer surface.
Excavator drag sprocket oil leakage
The four-wheel belt is very familiar to the old drivers who deal with excavators every day. Generally, the four-wheel belt is a vulnerable part. If it is broken or worn out, you can just ask the boss to replace it.
Excavators often "drop the chain"
Excavator off-chain, commonly known as off-chain, means that the track is separated from the track formed by the drive wheel, supporting roller, guide wheel, and supporting sprocket. Since the excavator often works in some harsh environments, and the crawler is a part that directly contacts the ground, when the working ground is bad and the operation is improper, it will often cause the chain to be disconnected. Let's list a few common reasons below, and analyze how to avoid dropping the chain.
Little knowledge about excavators
The small arm of the excavator is a laborious lever, and the pin in the middle is the fulcrum. Up is the big arm, down is the forearm! The longer the arm, the less effort it takes, on the contrary, the more effort it takes! At this time, the boom is the longest, so the digging force of the forearm is the largest at this angle!
Komatsu chassis parts - guide wheel replacement method
The guide wheel is an important part in the walking system of large-scale construction machinery such as excavators. It is installed on the track to guide the track. Its main function is to guide the correct winding of the track.
Be honest and do things honestly!
Message
Cheng Lu
Contact Us
Add：No. 68, Lianhe West 1st Road, Xiaolan Economic and Technological Development Zone, Nanchang County, Nanchang, Jiangxi Province
Tel：0791-86596887
Tel：18720063536
E-mail：jxjgwz@163.com
